Kia Soul: Installation
When installing, O-rings of clutch tube should be replaced with
a new one.
|
| 1. |
Install in the reverse order of removal.
|
| 2. |
After be equipped, perform bleeding air procedure after pouring
the brake fluid.
(Refer to Clutch System - "Clutch release cylinder")
|
Removal
1.
Remove the air cleaner assembly.
G 1.6 GDI (Refer to Engine Mechanical System - "Air Cleaner")
G 2.0 GDI (Refer to Engine Mechanical System - " ...
See also:
Rear Pillar Trim Component Location
1. Rear pillar trim
...
Hazard Lamp Switch Inspection
1.
The SJB can be diagnosed by using the GDS. The SJB communicates
with the GDS which then displays inputs and outputs along with codes.
It will be able to ...
SRS Control Module (SRSCM). Removal
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...