Kia Soul: SRS Control Module (SRSCM). Removal
| 1. |
Remove the ignition key from the vehicle.
|
| 2. |
Disconnect the battery negative cable and wait for at least three
minutes before beginning work.
|
| 3. |
Disconnect the DAB, PAB, SAB, CAB and BPT connectors.
|
| 4. |
Remove the floor console.
(Refer to Body - "Floor console")
|
| 5. |
Remove the rear heating joint duct (A).
|
| 6. |
Pull up the lock of the SRSCM connector and disconnect the connector
(A).
|
| 7. |
Remove the SRSCM mounting bolts(3EA) from the SRSCM, then remove
the SRSCM.
|
SRS Control Module (SRSCM). Installation
1.
Remove the ignition key from the vehicle.
2.
Disconnect the battery negative cable and wait for at least three
minutes before beginning ...
See also:
Crankshaft Position Sensor (CKPS). Troubleshooting
Waveform
This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft
Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition
timing by using ...
Vehicle stability management (VSM)
This system provides further enhancements to vehicle stability and steering responses
when a vehicle is driving on a slippery road or a vehicle detected changes in coefficient
of friction between ...
Overhead Console Lamp Removal
1.
Disconnect the negative (-) battery terminal.
2.
Remove the mounting screws (2EA).
And then remove the overhead con ...