Kia Soul: Rear Seat Belt Retractor Replacement - Rear Seat Belt - Body (Interior and Exterior)Kia Soul: Rear Seat Belt Retractor Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Rear Seat Belt / Rear Seat Belt Retractor Replacement

  
•
When installing the belt, make sure not to damage the retractor.
1.
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
2.
Loosen the rear seat belt upper anchor (A) mounting bolt.
3.
After loosening the mounting bolt, then remove the rear seat belt retractor (B).
Tightening torque :
39.2 ~ 53.9 N.m (4.0 ~ 5.5 kgf.m, 28.8 ~ 39.8 lb-ft)

4.
Install in the reverse order of removal.
  
•
Make sure the connector is plugged in properly.
•
Replace any damaged clips.
    Rear Seat Belt Retractor Component Location
    1. Rear seat belt retractor ...

    Rear Center Seat Belt Retractor Component Location
    1. Rear center seat belt retractor ...

    See also:

    Rear Door Side Weatherstrip Replacement
    1. Loosen the rear door checker (B) mounting bolt. Tightening torque : 16.7 ~ 21.6 N.m (1.7 ~ 2.2 kgf.m, 12.3 ~ 15.9 lb-ft) ...

    Crankshaft Position Sensor (CKPS). Troubleshooting
    Waveform This example shows a typical Crankshaft Position Sensor(CkPS) and Camshaft Position Sensor(CMPS) waveform at idle.The PCM controls the injection and ignition timing by using ...

    Master Cylinder. Removal
    Master Cylinder assembly 1. Turn ignition switch OFF and disconnect the negative (-) battery cable. 2. Remove the ECM. (Refer ...