Kia Soul: Power Window Switch Inspection
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim.
(Refer to Body - "Front Door Trim")
|
| 3. |
Disconnect the connector (A) from the power window switch
module.
|
| 4. |
Check for continuity between the terminals in each switch
position according to the table.
[Driver/Assist Safety]
[Driver Auto Down]
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the front door trim panel.
(Refer to Body - "Front Door Trim")
|
| 3. |
Disconnect the connector (A) from the switch.
|
| 4. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is
not normal, replace the switch.
[Safety]
[Manual]
|
| 1. |
Disconnect the negative (-) battery terminal.
|
| 2. |
Remove the rear door trim panel.
(Refer to Body - "Rear Door Trim")
|
| 3. |
Disconnect the connector (A) from the switch.
|
| 4. |
Check for continuity between the terminals in each switch
position according to the table. If the continuity condition is
not normal, replace the switch.
[With Seat Heater]
[Without Seat Heater]
|
Power Window Switch Circuit Diagram
Driver Power Window Switch
Assist Power Window Switch
Rear Power Window Switch
...
Power Window Switch Removal
Driver Power Window Switch
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door trim.
(Refe ...
See also:
Heated Oxygen Sensor (HO2S). Description and Operation
Description
Heated Oxygen Sensor (HO2S) consists of zirconium and alumina and is installed
both upstream and downstream of the Manifold Catalytic Converter. The sensor
output voltage varies ...
Engine Room Under Cover Removal and Installation
Engine Room Under Cover
1.
Remove the engine room under cover (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft ...
Power Door Mirror Actuator Inspection
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front door quadrant cover (A).
...