Kia Soul: Panorama Sunroof Motor Inspection
Kia Soul 2014-2019 PS Service Manual / Body Electrical System / Panorama Sunroof / Panorama Sunroof Motor Inspection
1. |
Close the panorama sunroof glass and blind completely (Full
close position).
|
2. |
Disconnect the negative (-) battery terminal.
|
3. |
Remove the roof trim assembly.
(Refer to Body - "Roof Trim")
|
4. |
Remove the panorama sunroof glass motor (A) after loosening
the screws and disconnecting the connector.
|
5. |
Check the wiring connector of the panorama sunroof glass motor
as below table.
|
6. |
Remove the blind motor (A) after loosening the screws and
disconnecting the connector.
|
7. |
Check the wiring connector of the blind motor as below table.
|
8. |
Connect the panorama sunroof glass and blind motor and each
connectors.
|
9. |
Connect the negative (-) battery terminal.
|
10. |
Start the vehicle engine.
|
11. |
Check the motor's operation by pressing the panorama sunroof
switch.
|
12. |
Pless the auto close switch after checking the motor's operation.
|
13. |
Install the panorama sunroof glass motor and blind motor.
And then perform the resetting procedure of the panorama sunroof.
|
Panorama Sunroof Switch Inspection
1. Disconnect the negative (-) battery terminal. 2. Open the sunglass case cover from the overhead console then remove the ...Panorama Sunroof Motor Replacement
Resetting The Panoramaroof Whenever the vehicle battery is disconnected or discharged, or you use the emergency handle to operate the panoramaroof, you have to reset your panoramaroo ...See also:
Category
Press the
key
Set through the
TUNE
knob
The display will indicate the category menus, highlight the category that
the current channel belongs to.
In the Category List Mode, p ...
Line Pressure Control Solenoid Valve. Description
line pressure control solenoid valve is attached to the valve body. This
variable force solenoid valve directly controls the hydraulic pressure inside
the line pressure.
...
Removal
1.
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
2.
Disconnect the clutch switch connector (A).
...