Kia Soul: Removal
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Disconnect the clutch switch connector (A).
|
3. |
Remove the clutch switch (B).
|
Inspection
Signal Circuit Inspection 1. Check clutch switch pull-up voltage (1) IG KEY "OFF", ENGINE "OFF". ...Installation
1. Install in the reverse order of removal. (1) Tighten the nut with the specified torque. Tightening ...See also:
Sunvisor Component Location
1. Sunvisor
2. Retainer
...
Input Speed Sensor. Inspection
1.
Check signal waveform of Input & output speed sensor using the
GDS.
Specification:
Refer to "Signal Wave Form" section.
...
Special Service Tools
Tool Name / Number
Illustration
Description
Hog ring clip installer
09880-4F000
...