Kia Soul: Engine Coolant Temperature Sensor (ECTS). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Engine Coolant Temperature Sensor (ECTS). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Engine Coolant Temperature Sensor (ECTS). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Remove the ECTS (Refer to "Removal").
3.
After immersing the thermistor of the sensor into engine coolant, measure resistance between the ECTS terminals 1 and 3.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the engine coolant temperature sensor connector (A).
3.
Disconnect the ignition coil connector (A) and CMPS connector (B).
4.
Unfasten the harness bracket (C) and Make a gap for removing high pressure fuel pipe by moving the bracket (C).
5.
Remove the vacuum pipe mounting bolts (A).
6.
Remove the engine coolant temperature sensor (B).

7.
Fill with engine coolant.
(Refer to Engine Mechanical System -"Coolant")

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
•
Apply the engine coolant to the O-ring.
  
•
Insert the sensor in the installation hole and be careful not to damage.
1.
Install in the reverse order of removal.
Engine Coolant Temperature Sensor mounting :
29.4 ~ 39.2 N.m (3.0 ~ 4.0 kgf.m, 21.7 ~ 28.9 lb-ft)
    Engine Coolant Temperature Sensor (ECTS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Crankshaft Position Sensor (CKPS). Description and Operation
    Description Crankshaft Position Sensor (CKPS) detects the crankshaft position and is one of the most important sensors of the engine control system. If there is no CKPS signal input, the eng ...

    See also:

    Inspection
    1. Check for damage to boot. 2. Check for deformation to clutch release fork. 3. Check for deformation to clutc ...

    Wheel alignment and tire balance
    The wheels on your vehicle were aligned and balanced carefully at the factory to give you the longest tire life and best overall performance. In most cases, you will not need to have your wheels al ...

    Crankshaft Position Sensor (CKPS). Repair procedures
    Inspection 1. Check signal waveform of CKPS and CMPS using a GDS. Specification: Refer to “Waveform” Removal ...