Kia Soul: Drive shafts and boots Inspection
1. |
Check the drive shaft boots for loose clamps, cracks, grease leaks,
kinks or damage.
|
Disc brakes and pads Replacement
Front brake pads 1. Remove the front wheel & tire. 2. Loosen the guide rod bolt (B) and pivot the caliper body (A) up out of the wa ...Parking Brake
Inspect the parking brake system including the parking brake lever (or pedal) and cables. Adjustment Parking Brake Lever Stroke Adjustment 1. Remove the rear console ...See also:
Distributing the sealant
11. Immediately drive approximately 4~6miles (7~10km or, about 10min) to evenly
distribute the sealant in the tire.
Do not exceed a speed of 50 mph (80 km/h). If possible, do not fall below a speed ...
Component Replacement after Deployment
Before doing any SRS repairs, use the GDS to check for DTCs. Refer
to the Diagnostic Trouble Code list for repairing of ...
Tire terminology and definitions
Air Pressure: The amount of air inside the tire pressing outward on the tire.
Air pressure is expressed in pounds per square inch (psi) or kilopascal (kPa).
Accessory Weight: This means the combine ...