Kia Soul: CVVT & Camshaft Removal
1. |
Remove the cylinder head cover.
(Refer to Cylinder Head Assembly - "Cylinder Head Cover")
|
2. |
Turn the crankshaft damper pulley so that No. 1 piston is at top
dead center.
|
3. |
Remove the exhaust oil control valve (OCV) adaptor (A).
|
4. |
Remove the camshaft bearing caps (A) in the order shown in the
picture.
|
5. |
Remove the engine mounting support bracket.
|
6. |
Remove the bolt (A) from the service hole in the timing chain
cover.
|
7. |
Lock the timing chain tensioner in the fully retracted position.
|
8. |
Separate the exhaust camshaft (A) from the exhaust CVVT by removing
the bolt.
|
9. |
Remove the exhaust CVVT (A) from the timing chain.
|
10. |
Remove the intake CVVT & camshaft (A).
|
11. |
Remove the intake CVVT (A) from the intake camshaft (B).
|
[CVVT System Mode]
(1) Low Speed / Low Load (2) Part Load (3) Low Speed / High Load (4) High Speed / High Load ...CVVT & Camshaft Inspection
Camshaft 1. Measure the height of the cam lobe using a micrometer and check the surface of the cam lob for wear and tear. If necessary, replace the camshaft. ...See also:
Battery Cleaning
1.
Make sure the ignition switch and all accessories are in the OFF
position.
2.
Disconnect the battery cables (negative first).
...
Air cleaner
Filter replacement
It must be replaced when necessary, and should not be washed.
You can clean the filter when inspecting the air cleaner element.
Clean the filter by using compressed air.
1. ...
Hood Latch Release Handle Replacement
1.
Using a screwdriver or remover, remove the hood release handle
(A).
...