Kia Soul: Battery Cleaning
1. |
Make sure the ignition switch and all accessories are in the OFF
position.
|
2. |
Disconnect the battery cables (negative first).
|
3. |
Remove the battery from the vehicle.
|
4. |
Inspect the battery tray for damage caused by the loss of electrolyte.
If acid damage is present, it will be necessary to clean the area with
a solution of clean warm water and baking soda. Scrub the area with
a stiff brush and wipe off with a cloth moistened with baking soda and
water.
|
5. |
Clean the top of the battery with the same solution as described
above.
|
6. |
Inspect the battery case and cover for cracks. If cracks are present,
the battery must be replaced.
|
7. |
Clean the battery posts with a suitable battery post tool.
|
8. |
Clean the inside surface of the terminal clamps with a suitable
battery cleaning tool. Replace damaged or frayed cables and broken terminal
clamps.
|
9. |
Install the battery in the vehicle.
|
10. |
Connect the cable terminals to the battery post, making sure tops
of the terminals are flush with the tops of the posts .
|
11. |
Tighten the terminal nuts securely.
|
12. |
Coat all connections with light mineral grease after tightening.
|
Battery Vehicle parasitic current inspection
1. Turn the all electric devices OFF, and then turn the ignition switch OFF. 2. Close all doors except the engine hood, and then lock all d ...See also:
General Information
1.
Check & Change intervals
Check & Replenishment
Change
Capacity
Oil specification
...
Antenna (if equipped)
Your vehicle uses a roof antenna to receive AM or/and FM broadcast signals. This
antenna is removable. To remove the roof antenna, turn it counterclockwise. To install
the roof antenna, turn i ...
Headlight, position light, turn signal light, side marker light and front fog
light bulb replacement
(1) Headlight (High)
(2) Headlight (Low)
(3) Front side marker light
(4) Front turn signal/Position light
(5) Front fog light (if equipped)
If the headlight aiming adjustment is necessary after ...