Kia Soul: Water Temperature Control Assembly Removal and Installation
Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Removal and Installation
1. |
Remove the engine cover.
|
2. |
Drain the engine coolant.
(Refer to Cooling System - "Coolant")
|
3. |
Remove the air cleaner assembly.
(Refer to Intake And Exhaust System - “Air Cleaner”)
|
4. |
Disconnect the water temperature sensor connector (A).
|
5. |
Disconnect the radiator upper hose and the heater hose from the
water temperature control assembly.
|
6. |
Disconnect the water hose (A) and then remove the water temperature
control assembly (B) with the O-ring.
|
7. |
Install in the reverse order of removal.
|
8. |
Fill the engine coolant.
(Refer to Cooling System - "Coolant")
|
9. |
Start the engine and check for leaks.
|
Water Temperature Control Assembly Components
1. Water temperature assembly 2. Water temperature sensor 3. Gasket 4. Heater pipe ...Water pump Components
1. Gasket 2. Water pump 3. Water pump pulley ...See also:
Tire specification and pressure label
The tires supplied on your new vehicle are chosen to provide the best performance
for normal driving.
The tire label located on the driver's side center pillar gives the tire pressures
reco ...
Battery replacement
A transmitter uses a 3 volt lithium battery which will normally last for several
years. When replacement is necessary, use the following procedure.
1. Insert a slim tool into the slot and gently ...
Using the Tire Mobility Kit
1. Detach the speed restriction label (0) from the sealant bottle (1), and place
it in a highly visible place inside the vehicle such as on the steering wheel to
remind the driver not to drive too ...