Kia Soul: Using Voice Recognition - Voice recognition - Features of your vehicleKia Soul: Using Voice Recognition

Kia Soul 2014-2019 PS Owner's Manual / Features of your vehicle / Voice recognition / Using Voice Recognition

Starting Voice Recognition

Shortly press the key on the steering wheel. Say a command key on the steering wheel. Say a command

If prompt feedback is in [ON], then the system will say “Please say a command

If prompt feedback is in [ON], then the system will say “Please say a command after the beep (BEEP)”

  • If prompt feedback is in [OFF] mode, then the system will only say “(BEEP)”
  • To change Prompt Feedback [On]/[Off], go to  [System] [System] [Prompt Feedback] [Prompt Feedback]
  • For proper recognition, say the command after the voice instruction and beep tone.

Skipping Prompt Messages

While prompt message is being stated Shortly press the Shortly press the key on the steering remote controller key on the steering remote controller

The prompt message is immediately ended and the beep tone will sound. After the “beep”, say the voice command.

Re-starting Voice Recognition

While system waits for a command Shortly press the Shortly press the key on the steering remote controller key on the steering remote controller

The command wait state is immediately ended and the beep ton will sound. After the “beep”, say the voice command.

    Voice recognition
    ...

    Ending voice recognition
    While Voice Recognition is operating Press and hold the key on the steering remote controller While using voice command, pressing any steering wheel control or a different key will end vo ...

    See also:

    Description
    BCM CAN Communication Function Function Description Timer Defroster When IGN ON, Rear Heater Control Function ...

    Intake Actuator Replacement
    1. Disconnect the negative (-) battery terminal. 2. Remove the glove box housing. (Refer to Body - "Glove Box Housing") ...

    Intake Actuator Description
    The intake actuator is located at the blower unit. It regulates the intake door by a signal from the control unit. Pressing the intake selection switch will shift between recirculation and fr ...