•
|
Put on gloves to protect your hands.
|
|
•
|
Use seat covers to avoid damaging any surfaces.
|
|
1. |
Remove the rear pillar trim.
(Refer to Interior Trim - "Rear Pillar Trim")
|
2. |
Loosen the quarter fixed glass (A) mounting nuts.
Tightening torque :
3.9 ~ 4.4 N.m (0.4 ~ 0.45 kgf.m, 2.9 ~ 3.3 lb-ft)
|
|
3. |
Cut out the quarter fixed glass sealant using the utility knife.
• |
Do not scrape down to the painted surface of the
body; damaged paint will interfere with proper bonding.
|
|
• |
Remove the rubber dam and fastereners from the
body.
|
• |
Mask off surrounding surfaces before painting.
|
|
|
4. |
Remove the quarter fixed glass.
|
1. Quarter fixed glass
...
1.
With a putt knife, scrape the old adhesive smooth to a thickness
of about 2mm (0.08 in.) on the bonding surface around the entire quarter
fixed glass flange.
...
See also:
Operation
Evaporative System Monitoring
Evaporative And ORVR Emission Control System
This system consists of a fill vent valve, fuel shut-off valve, fuel cut
valve (for roll over), two way val ...
Engine Coolant Temperature Sensor (ECTS). Description and Operation
Description
Engine Coolant Temperature Sensor (ECTS) is located in the engine coolant
passage of the cylinder head for detecting the engine coolant temperature. The
ECTS uses a thermistor th ...
Fuel Tank Pressure Sensor (FTPS). Description and Operation
Description
Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission
control system and is installed on the fuel tank, the fuel pump, or the canister.
It checks the purge ...