Kia Soul: Installation - Clutch Release Fork and Clutch Release Bearing - Clutch SystemKia Soul: Installation

Kia Soul 2014-2019 PS Service Manual / Clutch System / Clutch Release Fork and Clutch Release Bearing / Installation

1.
Install the boot (A).
2.
Install the clip to the clutch release fork.
3.
Apply to grease in location A, B and C.
Location
 Quantity (g)
 Remarks
A
 0.3 ~ 0.5
 Release bearing & Fork
B
 0.5 ~ 1.0
 Release Fork & Fulcrum
C
 0.4 ~ 0.8
 Release cylinder & Fork

4.
Apply the grease to the hole surface of the clutch release bearing all around.
Specified grease: CASMOLY L9508
Amount: 0.5 ~ 1.0 g

5.
Install the clutch release fork (B), clutch release bearing (A).
6.
Install the transaxle assembly.
G 1.6 GDI (Refer to Manual Transaxle System - " Manual Transaxle")
G 2.0 GDI (Refer to Manual Transaxle System - " Manual Transaxle")
    Inspection
    1. Check for damage to boot. 2. Check for deformation to clutch release fork. 3. Check for deformation to clutc ...

    Manual Transaxle System
    ...

    See also:

    Rail Pressure Sensor (RPS). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    SRS Control Module (SRSCM). Description
    The primary purpose of the SRSCM (Supplemental Restraints System Control Module) is to discriminate between an event that warrants restraint system deployment and an event that does not. The ...

    Inspection
    Signal Circuit Inspection 1. Check ignition lock switch pull-up voltage (1) IG KEY "OFF", ENGINE "OFF". ...