Kia Soul: Fuel Tank Pressure Sensor (FTPS). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: Fuel Tank Pressure Sensor (FTPS). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / Fuel Tank Pressure Sensor (FTPS). Repair procedures

Inspection

1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the FTPS.

Specification: Refer to "Specification"

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Remove the rear seat cushion.
3.
Remove the fuel pump service cover (A).

4.
Disconnect the fuel tank pressure sensor connector (A).
5.
Remove the fuel tank pressure sensor (B) after releasing the hooks vertically.

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. In this case, use it after inspecting.
  
•
Insert the sensor in the installation hole and be careful not to damage when installation.
1.
Install in the reverse order of removal.
    Injector. Description and Operation
    Description The GDI injector is similar to a standard injector, but sprays fuel at a much higher pressure directly into the combustion chamber and has a swirl disc to get the fuel swirling a ...

    See also:

    This device complies with Part 15 of the FCC rules.
    Operation is subject to the following two conditions: 1.This device may not cause harmful interference, and 2.This device must accept any interference received, including interference that may cau ...

    Head Lamps Installation
    1. Install the head lamp bulbs. 2. Reassemble the head lamp bulb covers. 3. Reassembl ...

    Memory Information
    Displays currently used memory and total system memory. Select [Memory Information]  OK The currently used memory is displayed on the left side while the total system memory is displayed ...