Kia Soul: Fuel Pump. Repair procedures - Fuel Delivery System - Engine Control / Fuel SystemKia Soul: Fuel Pump. Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Fuel Delivery System / Fuel Pump. Repair procedures

Inspection

[Fuel pump]
1. Turn ignition switch OFF and disconnect the negative (-)battery cable.
2. Remove the fuel pump assembly.
3. Check that motor operates properly when applying battery voltage to terminals 2 and 4 of fuel pump connector (A).

 
Pin No. discription
1 Fuel sender signal
2 Fuel pump (+)
3 Fuel sender ground
4 Fuel pump (-)
[Fuel sender]
1. Turn ignition switch OFF and disconnect the negative (-)battery cable.
2. Remove the fuel pump assembly.
3. Using an ohmmeter, measure the resistance between terminals 1 and 3 of sender connector (A) at each float level.

 
Pin No. discription
1 Fuel sender signal
2 Fuel pump (+)
3 Fuel sender ground
4 Fuel pump (-)
4. Also check that the resistance changes smoothly when the float is moved from "E" to "F".  
Position Resistance (Ω) Capacity (ℓ)
E 197 ~ 203 4.3
 1/2 64.2 ~ 68.2 26.4
F 6 ~ 10 51.3

Removal

1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pressure in Fuel Line").
2. Remove the rear seat.
3. Remove the fuel pump service cover (A).

4. Disconnect the fuel pump connector (A) and the fuel tank pressure sensor connector (B).
5. Disconnect the fuel feed tube quick connector (C) and the vapor tube quick-connector (D).
6. Remove the plate cover (E) after removing the mounting bolts.

7. Remove the fuel pump from the fuel tank.

Installation

1. Install in the reverse order of removal.
  
 
Be careful of fuel pump direction when installing (Refer to the groove in the fuel tank).
Fuel pump plate cover mounting bolt : 2.0 ~ 3.0 N.m (0.2 ~ 0.3 kgf.m, 1.4 ~ 2.2lb-ft)
    Fuel Tank. Repair procedures
    Removal 1. Release the residual pressure in fuel line (Refer to the Fuel Delivery System - Repair Procedures - "Release Residual Pres ...

    Fuel Filter. Repair procedures
    Removal 1. Remove the fuel pump. (Refer to Fuel Delivery System - "Fuel Pump") ...

    See also:

    Timing Chain Removal
    1. Turn the crankshaft pulley clockwise, and align its groove with the timing mark of the timing chain cover. 2. Remove the timing ...

    Highway driving
    Tires Adjust the tire inflation pressures to specification. Low tire inflation pressures will result in overheating and possible failure of the tires. Avoid using worn or damaged tires which may r ...

    Pre-tensioner seat belt
    Your vehicle is equipped with driver's and front passenger's pre-tensioner seat belts. The purpose of the pretensioner is to make sure that the seat belts fit tightly against the occupan ...