Kia Soul: Floor Console Assembly Replacement - Floor Console - Body (Interior and Exterior)Kia Soul: Floor Console Assembly Replacement

Kia Soul 2014-2019 PS Service Manual / Body (Interior and Exterior) / Floor Console / Floor Console Assembly Replacement

[M/T]
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
Detach the gear boots (A).
2.
Using a screwdriver or remover, remove the console upper cover (A).
3.
Disconnect the multimedia jcak connectors (A).
4.
Using a screwdriver or remover, remove the parking brake cover (A).
5.
Reomove the hole cover (A).
6.
Remove it console side cover (A) by pushing it rearward.
[LH]

  
•
When installing, insert the front of console side cover (B) to hook (A).

[RH]

  
•
When installing, insert the front of console side cover (B) to hook (A).

7.
After loosening the mounting screws and bolts, then remove the floor console assembly (A).
8.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
•
Replace any damaged clips.
[A/T]
  
•
Put on gloves to protect your hands.
  
•
When prying with a flat-tip screwdriver, wrap it with protective tape, and apply protective tape around the related parts, to prevent damage.
•
Use a plastic panel removal tool to remove interior trim pieces to protect from marring the surface.
•
Take care not to bend or scratch the trim and panels.
1.
To remove the gear knob (A) and gear boots (B) pull both of it up.
2.
Using a screwdriver or remover, remove the console upper cover (A).
3.
Disconnect the indicator connector (A) and start/stop button switch connector (B).
4.
Disconnect the multimedia jcak connectors (A).

  
•
Console Upper Cover Connector Mounting Location

Multimedia jcak connector
Start/stop button switch connector
Indicator connector
5.
Using a screwdriver or remover, remove the parking brake cover (A).
6.
Reomove the hole cover (A).
7.
Remove it console side cover (A) by pushing it rearward.
[LH]

  
•
When installing, insert the front of console side cover (B) to hook (A).

[RH]

  
•
When installing, insert the front of console side cover (B) to hook (A).

8.
After loosening the mounting screws and bolts, then remove the floor console assembly (A).
9.
Install in the reverse order of removal.
  
•
Make sure the connector is connected properly.
•
Replace any damaged clips.
    Floor Console Assembly Component Location
    1. Floor console assembly ...

    Rear Console Cover Component Location
    1. Rear console cover ...

    See also:

    Seat belt warning (for driver’s seat)
    The driver's seat belt warning light and chime will activate to the following table when the ignition switch is in "ON" position. *1Warning pattern repeats 11 times with an interv ...

    Emergency tailgate safety release
    Your vehicle is equipped with the emergency tailgate safety release lever located on the bottom of the tailgate. When someone is inadvertently locked in the luggage compartment, the tailgate can ...

    Troubleshooting
    Trouble Symptom Probable cause Remedy Vehicle pulls to one side Scoring of driveshaft ball joint Replace Wear, rattle or scoring of wheel b ...