Kia Soul: ESC Control Module. Removal
1. |
Turn ignition switch OFF and disconnect the negative (-) battery
cable.
|
2. |
Remove the ECM.
(Refer to Engine Control / Fuel System - “Engine Control Module
(ECM)”)
|
3. |
Remove the brake fluid from the master cylinder reservoir with
a syringe.
|
4. |
Disconnect the brake tube (A) from the master cylinder by loosening
the tube flare nut.
|
5. |
Pull up the lock of the HECU connector and then disconnect the
connector (B) .
|
6. |
Loosen the flare nuts and then remove the brake tube (A).
|
7. |
Disconnect the brake tubes (B) from the HECU by unlocking the
nuts counterclockwise with a spanner.
|
8. |
Remove the engine room under cover. [G2.0 NU GDI only]
(Refer to Engine Mechanical System - "Engine Room Under Cover")
|
9. |
Install the jack under the edge of lower oil pan to support the
engine. [G2.0 NU GDI only]
|
10. |
Remove the engine mounting support bracket (A). [G2.0 NU GDI only]
|
11. |
Slowly lower the jack. [G2.0 NU GDI only]
|
12. |
Loosen the HECU bracket nuts (A) and then remove HECU and bracket.
|
13. |
Remove the bolts and then remove the bracket from HECU.
|
ESC Control Module. Components
1. Front - left tube 2. Rear - right tube 3. Rear - left tube 4. Front - right tube 5. MC2 6. MC1 7. ESC control module(HECU) 8. Bracket ...ESC Control Module. Installation
1. Install in the reverse order of removal. 2. Tighten the HECU mounting bolts and nuts to the specified torque. 3. ...See also:
Drive Belt Tensioner Removal and Installation
1.
Remove the drive belt.
(Refer to Timing System - "Dreve Belt")
2.
Remove the alternator.
(Refer to Engine Electrica ...
Checking tire inflation pressure
Check your tires once a month or more.
Also, check the tire pressure of the spare tire.
How to check
Use a good quality gauge to check tire pressure. You cannot tell if your tires
are properly in ...
Front Driveshaft Replacement
1.
Loosen the wheel nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the front wheel and tire (A) fro ...