Kia Soul: Engine And Transmission Assembly Installation
Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine And Transmission Assembly Installation
Installation is in the reverse order of removal.
Perform the following :
| • |
Adjust a shift cable.
|
| • |
Adjust the throttle cable.
|
| • |
Refill engine with engine oil.
|
| • |
Refill a transaxle with fluid.
|
| • |
Refill power steering fluid.
|
| • |
Refill a radiator and a reservoir tank with engine coolant.
|
| • |
Place a heater control knob on "HOT" position.
|
| • |
Clean battery posts and cable terminals and assemble.
|
| • |
Inspect for fuel leakage.
|
| - |
After assemble the fuel line, turn on the ignition switch (do
not operate the starter) so that the fuel pump runs for approximately
two seconds and fuel line pressurizes.
|
| - |
Repeat this operation two or three times, then check for fuel
leakage at any point in the fuel line.
|
| • |
Bleed air from the cooling system.
|
| - |
Start engine and let it run until it warms up. (until the radiator
fan operates 3 or 4 times.)
|
| - |
Turn Off the engine. Check the level in the radiator, add coolant
if needed. This will allow trapped air to be removed from the cooling
system.
|
Engine And Transmission Assembly Removal
•
Use fender covers to avoid damaging painted surfaces.
â ...
See also:
Drive Plate Removal and Installation
1.
Remove the automatic transaxle .
(Refer to Automatic Transaxle System - "Automatic Transaxle")
2.
Remove the drive plate(A ...
Smart Key Unit Installation
Smart Key Unit
1.
Install the smart key unit.
2.
Connect the connector and install the smart key unit.
...
Knock Sensor (KS). Knock Sensor (KS).
Removal
1.
Turn the ignition switch OFF and disconnect the battery negative
(-) cable.
2.
Remove the engine room under cover.
(Re ...