Kia Soul: Cylinder Block Disassembly
Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Cylinder Block / Cylinder Block Disassembly
|
|
1. |
Remove the engine and transaxle assembly from the vehicle.
(Refer to Engine and Transaxle Assembly - "Engine and Transaxle
Assembly")
|
2. |
Remove the transaxle assembly from the engine assembly.
|
3. |
Remove the drive plate or flywheel.
|
4. |
Remove the rear oil seal.
(Refer to Cylinder Block Assembly - "Rear Oil Seal")
|
5. |
Install the engine assembly to engine stand for disassembly.
|
6. |
Remove the intake manifold.
(Refer to Intake And Exhaust System - "Intake Manifold")
|
7. |
Remove the exhaust manifold.
(Refer to Intake And Exhaust System - "Exhaust Manifold")
|
8. |
Remove the timing chain.
(Refer to Timing System - "Timing Chain")
|
9. |
Remove the cylinder head assembly.
(Refer to Cylinder Head Assembly - "Cylinder Head")
|
10. |
Remove the oil filter.
(Refer to Lubrication System - "Oil Filter")
|
11. |
Remove the oil pressure switch.
(Refer to Lubrication System - "Oil Pressure Switch")
|
12. |
Remove the crankshaft position sensor.
(Refer to Engine Control / Fuel System - "Crankshaft Position
Sensor (CKPS)")
|
13. |
Remove the oil pan and the oil screen.
(Refer to Lubrication System - "Oil Pan")
|
14. |
Remove the ladder frame.
(Refer to Cylinder Block Assembly - "Piston And Connecting Rod")
|
15. |
Check the connecting rod side clearance.
(Refer to Cylinder Block Assembly - "Piston And Connecting Rod")
|
16. |
Check the connecting rod bearing cap oil clearance.
(Refer to Cylinder Block Assembly - "Piston And Connecting Rod")
|
17. |
Remove the piston and connecting rod assemblies.
(Refer to Cylinder Block Assembly - "Piston And Connecting Rod")
|
18. |
Check the main bearing oil clearance.
(Refer to Cylinder Block Assembly - "Crankshaft")
|
19. |
Check the crankshaft end play.
(Refer to Cylinder Block Assembly - "Crankshaft")
|
20. |
Remove the crankshaft.
(Refer to Cylinder Block Assembly - "Crankshaft")
|
21. |
Remove the water inlet fitting and thermostat.
(Refer to Cooling System - "Thermostat")
|
22. |
Remove the knock sensor.
(Refer to Engine Control / Fuel System - "Knock Sensor (KS)")
|
Cylinder Block Components
1. Cylinder block 2. Ladder frame 3. Crank shaft 4. Crank shaft upper bearing 5. Crank shaft lower bearing 6. Thrust bearing 7.&nbs ...Cylinder Block Inspection
1. Using a gasket scraper, remove all the gasket material from the top surface of the cylinder block. 2. Using a soft brush and solvent, th ...See also:
Changing the coolant
Have the coolant changed by an authorized Kia dealer according to the Maintenance
Schedule at the beginning of this section.
Put a thick cloth around the radiator cap before refilling the coolant i ...
Ambient Temperature Sensor Replacement
1.
Disconnect the negative (-) battery terminal.
2.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
...
Auto stop
Type A
Type B
To stop the engine in idle stop mode
Stop the vehicle completely by pressing the brake pedal.
You must reach a speed of at least 5 mph (8 km/h) since last idle stop.
The engine ...