Kia Soul: CVVT Oil Control Valve (OCV). Repair procedures - Engine Control System - Engine Control / Fuel SystemKia Soul: CVVT Oil Control Valve (OCV). Repair procedures

Kia Soul 2014-2019 PS Service Manual / Engine Control / Fuel System / Engine Control System / CVVT Oil Control Valve (OCV). Repair procedures

Inspection

1.
Turn the ignition switch OFF.
2.
Disconnect the OCV connector.
3.
Measure resistance between the OCV terminals 1 and 2.
4.
Check that the resistance is within the specification.
Specification: Refer to “Specification”

Removal

1.
Turn the ignition switch OFF and disconnect the battery negative (-) cable.
2.
Disconnect the CVVT oil control valve connector (A).
3.
Remove the mounting bolt (B), and then remove the valve from the engine.
[Bank 1 / Intake]

[Bank 1 / Exhaust]

Installation

  
•
Install the component with the specified torques.
•
Note that internal damage may occur when the component is dropped. If the component has been dropped, inspect before installing.
  
•
Apply engine oil to the valve O-ring.
1.
Install in the reverse order of removal.
CVVT oil control valve installation bolt:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)
    CVVT Oil Control Valve (OCV). Schematic Diagrams
    Circuit Diagram (M/T) (A/T) ...

    Variable Intake Solenoid (VIS) Valve. Description and Operation
    Description Variable Intake manifold Solenoid (VIS) valve is installed on the intake manifold. The VIS valve controls the vacuum modulator which activates a valve in the intake manifold. The ...

    See also:

    Closing the fuel filler lid
    1. To install the cap, turn it clockwise until it “clicks”. This indicates that the cap is securely tightened. 2. Close the fuel filler lid and push it in lightly making sure that it is securel ...

    Installation
    1. Install in the reverse order of removal. (1) Tighten the nut with the specified torque. Tightening ...

    Crash Pad Lower Panel Component Location
    1. Crash pad lower panel ...