Kia Soul: Cruise Control Switch Inspection - Cruise Control System - Engine Electrical SystemKia Soul: Cruise Control Switch Inspection

Kia Soul 2014-2019 PS Service Manual / Engine Electrical System / Cruise Control System / Cruise Control Switch Inspection

[Measuring Resistance]
1.
Disconnect the cruise control switch connector from the control switch.
2.
Measure resistance between terminals on the control switch when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Resistance
[kΩ ± 5%]
CANCEL
 2 - 4
 0.18
SET–
 2 - 4
 0.33
RES+
 2 - 4
 0.55
CRUISE
 2 - 4
 0.88

3.
If not within specification, replace switch.
[Measuring Voltage]
1.
Connect the cruise control switch connector to the control switch.
2.
Measure voltage between terminals on the harness side connector when each function switch is ON (switch is depressed).
Function switch
 Terminal
 Voltage (V)
CANCEL
 2 - 4
 0.63 ~ 0.97
SET–
 2 - 4
 1.03 ~ 1.37
RES+
 2 - 4
 1.58 ~ 2.02
CRUISE
 2 - 4
 2.08 ~ 2.52

3.
If not within specification, replace switch.
    Cruise Control Switch Circuit Diagram
    ...

    Cruise Control Switch Removal
    1. Disconnect the negative (-) battery terminal. 2. Remove the driver airbag module. (Refer to the RT group) 3. ...

    See also:

    Fuel Additives
    Kia recommends that you use good quality gasolines treated with detergent additives such as TOP TIER Detergent Gasoline, which help prevent deposit formation in the engine. These gasolines will he ...

    Occupant Detection System (ODS). Installation
    1. Install in the reverse order of removal. 2. Reconnect the battery negative cable. 3. After installing the OD ...

    Front Disc Brake. Removal
    Brake caliper assembly 1. Remove the front wheel & tire. Tightening torque : 88.3 ~ 107.9 N.m (9.0 ~ 11.0 kgf.m, 65.1 ~ 79.6 lb-ft ...