Kia Soul: Crankshaft Damper Pulley Removal and Installation - Timing System - Engine Mechanical SystemKia Soul: Crankshaft Damper Pulley Removal and Installation

Kia Soul 2014-2019 PS Service Manual / Engine Mechanical System / Timing System / Crankshaft Damper Pulley Removal and Installation

1.
Remove the drive belt.
(Refer to Timing System - "Dreve Belt")
2.
Remove the engineroom under cover.
3.
Remove the passenger side front tire.
4.
Remove the crankshaft damper pulley (A).

Tightening torque :
46.1 ~ 52.0 N.m (4.7 ~ 5.3 kgf.m, 34.0 ~ 38.3 lb-ft) + 38 ~ 42°

  
There are two methods to hold the ring gear when removing or installing the crankshaft damper pulley.
•
Install the SST (09231-3N100 / 09231-2B100) to hold the ring gear after removing the starter.

•
Install the SST (09231-2W100 / 09231-3D100) to hold the ring gear after removing the dust cover.
1.
Remove the air guide bracket (A).


Tightening torque :
8.8 ~ 13.7 N.m (0.9 ~ 1.4 kgf.m, 6.5 ~ 10.1 lb-ft)

2.
Remove the dust cover (A) and unfasten the transaxle mounting bolt (B).

3.
Adjust the length of the holder nuts (A) so that the front plate of the holder (B) puts in the ring gear (C) teeth.
4.
Adjust the angle of the links (D), and fasten the bolt 70mm(2.7559in) in the original mounted hole.

5.
Tighten the bolts and nuts of the holder and links securely.

5.
When installing the pulley, the groove on the pulley should be positioned outside.

    Drive Belt Tensioner Removal and Installation
    1. Remove the drive belt. (Refer to Timing System - "Dreve Belt") 2. Remove the alternator. (Refer to Engine Electrica ...

    Front Oil Seal Components
    1. Front oil seal ...

    See also:

    Water pump Removal
    1. Drain the coolant. (Refer to Cooling System - "Coolant") 2. Remove the drive belt. (Refer to Timing System - " ...

    Crash Pad Center Panel Replacement
       • Put on gloves to protect your hands. ...

    Front Driveshaft Replacement
    1. Loosen the wheel nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) fro ...