Kia Soul: Accelerator Position Sensor (APS). Repair procedures
Inspection
1. |
Connect the GDS on the Data Link Connector (DLC).
|
2. |
Turn the ignition switch ON.
|
3. |
Measure the output voltage of the APS 1 and 2 at C.T and W.O.T.
|
Removal
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery
terminal.
|
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the mounting nuts (B).
|
4. |
Remove the cap (A)
|
5. |
Remove the mounting bolt (A), and then remove the accelerator
pedal module.
|
Installation
1. |
Install in the reverse order of removal.
|
Accelerator Position Sensor (APS). Schematic Diagrams
Circuit Diagram (M/T) (A/T) ...Fuel Tank Pressure Sensor (FTPS). Description and Operation
Description Fuel Tank Pressure Sensor (FTPS) is a component of the evaporative emission control system and is installed on the fuel tank, the fuel pump, or the canister. It checks the purge ...See also:
Gasoline containing alcohol and methanol
Gasohol, a mixture of gasoline and ethanol (also known as grain alcohol), and
gasoline or gasohol containing methanol (also known as wood alcohol) are being marketed
along with or instead of leade ...
Seat belt precautions
Infant or small child
All 50 states have child restraint laws. You should be aware of the specific
requirements in your state. Child and/or infant seats must be properly placed and
installed in t ...
SS-B Solenoid Valve(ON/OFF). Removal
1.
Remove the under cover.
(Refer to Engine Mechanical System - "Engine Room Under Cover")
2.
Remove the drain plug (A) and dr ...