Removal
1. |
Turn the ignition switch OFF and disconnect the negative (-) battery cable.
|
2. |
Disconnect the accelerator position sensor connector (A).
|
3. |
Remove the mounting nuts (B).
|
4. |
Remove the cap (A)
|
5. |
Remove the mounting bolt (A), and then remove the accelerator pedal module.
|
installation
1. |
Install in the reverse order of removal.
Accelerator pedal module mounting nut:
12.8 ~ 15.7 N.m (1.3 ~ 1.6 kgf.m, 9.4 ~ 11.6 lb-ft)
Accelerator pedal module mounting bolt:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
|
|
Removal
1.
Open the fuel filler door and unfasten the filler-neck assembly mounting bolts (A).
...
See also:
Driving in the rain
Rain and wet roads can make driving dangerous, especially if you’re not prepared
for the slick pavement. Here are a few things to consider when driving in the rain:
A heavy rainfall will m ...
Storage compartment
These compartments can be used to store small items.
To avoid possible theft, do not leave valuables in the storage compartment.
Always keep the storage compartment covers closed while dri ...
Description
Ignition timing is controlled by the electronic control ignition timing
system.
The standard reference ignition timing data for the engine operating conditions
are pre-pro grammed in the ...